Description

7.4V-11.1V Li-Po/Li-Ion Smart Balance Charger with Display

Digital display balancer charger for 7.4V-11.1V Li-po/Li-ion Battery!

Specifications:

Operation Instructions

1. Connect the DC power or AC adapter (14V, 1A) to the charger.

2. Connect battery pack to charger, make sure the polarity is connected in the right way, then charging will start automatically.

3. Charging LCD should be display battery voltage and capacity during charging.

Warning:

Never attempt to charge 2 battery packs simultaneously.
Never leave the charger unattended when it is connected to power supply.
Terminate charging when any malfunction is observed.
Keep away from dust, dump, water, heat, direct sunshine and vibration.
Never place charger on car seat, carpet or something similar.
Always place charger on heat-resistant, non-flammable and non-conductive surface.
Don’t charge the following types of battery:
- Lead Acid battery or VRLA.
- Ni-MH or Ni-Cd battery pack.
- Non-rechargeable battery (explosion hazard).
- Faulty or damaged battery.
- Any other types except for Li-Polymer and Li-Ion battery pack. Battery pack which consists of different type of cell or different brands.

⚠️ Airsoft Battery Safety: Always review our Airsoft Battery Safety Guide before charging LiPo or Li-Ion batteries.

Key Battery Charging Safety Guidelines:

Only use this charger with compatible LiPo or Li-Ion batteries, as specified.
Verify the battery voltage and cell count before charging.
Charge at the correct current (1C rate), unless the battery is rated for higher.
Never leave batteries unattended while charging.
Always charge in a fireproof LiPo-safe bag on a non-flammable surface.
Allow batteries to cool to room temperature before charging.
Inspect batteries for damage before each charge. Do not charge damaged or swollen batteries.
Do not attempt to charge batteries discharged below 3.3V per cell.

View AllClose